User:EvilJackCarver/research notes/Atmosia
DISCLAIMER: The information here is listed for record-keeping purposes only, and should only be relied upon at your own risk. The content displayed here is subject to change or be made useless, without warning and at any time.
I've found an Atmos setup that seems to work better than the one in the manual.
Pipe setup
The inlet line has two volume pumps on the vertical section, and a third on the actual to-filters line. All the filters are maxed, and the airmix gas mixer's demand pressure is also maxed. The master distro outlet pump, by the chair, is only set to 314 kPa, however - this way we don't lose all our air when we inevitably get a hull breach.
The to-mix line (yellow pipe) has a volume pump from the airmix in, and the gaspump is moved around the bend-pipe to face left. The bendpipe is replaced with a manifold, and at the right is a canister port to attach the portapumps to. This allows us to charge the portapumps and the two airtanks in stock to a tad over 9 MPa - useful for repressurising rooms after a breach, as you only have to run back for a new airtank half as often. ^RSpitz